INSTALLING
Continued
20
INSTALLING LOGS (Split Oak Design Models)
WARNING
Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Place front logs (#1L and #1R) on top of the grate. Make sure the notches in the bottom of the logs fit over the grate prongs (see Figure 22). Push back of logs flush with metal grate bar. Note: 18" model has only one front log.
2.Rest bottom middle log (#2) behind metal posts on front burner. Make sure the grooves in the bottom of the log fit over the grate. Bring the log forward next to the metal posts. The pegs on the log must be on top (see Figure 23).
3.Slide the grooves in the back of the rear log (#3) against the rear grate prongs. Make sure the peg on the log is on top (see Figure 24).
4.Place the top middle log (#4) on the bottom middle log (#2). Make sure the pegs of the bottom middle log fit securely in the holes of the top middle log (see Figure 25).
Front Log (#1L) | Bottom Middle Log (#2) | |
Peg | ||
Front Log (#1R) | Groove | |
Notch | ||
Metal Post | ||
|
Grate |
| Groove |
| |
Prongs |
|
| ||
|
|
| ||
Metal Grate Bar | Metal Post | Grate | ||
|
|
| ||
Figure 22 - Installing Front Logs | Figure 23 - Installing Bottom | |||
Middle Log (#2) | ||||
Groove | (#1L and #1R) | |||
|
| |||
|
|
| ||
in Back | Peg |
|
| |
of Log | Rear Log (#3) |
|
| |
Grate |
|
| Top Middle Log (#4) | |
Prong |
|
|
| |
Rear | Hole |
| ||
| Peg |
| ||
Burner |
|
| ||
Groove |
| Hole | ||
|
| |||
| in Back |
|
| |
| of Log |
|
| |
| Grate |
|
| |
| Prong |
|
| |
|
| Peg | Bottom | |
|
|
| Middle Log | |
Figure 24 - Installing Rear Log (#3) | Figure 25 - Installing Top Log (#4) | |||
103280
