
OWNER’S MANUAL
STOVE AND B-VENT BURNER SYSTEM INSTALLATION
Continued
INSTALLING OPTIONAL WIRELESS
NOTICE: Only use alkaline batter- ies (not included).
Installing Remote Receiver
1.Open bottom door on stove body and locate the switch plate on the left of the valve bracket.
2.Disconnect wires from THTP and TH on control valve that lead to the switch (see Figure 36, page 16). Discard switch plate, screws, and nuts.
3.Install
4.Place receiver into valve bracket and align holes (see Figure 40).
5.Use
6.Connect the wires from the receiver to the valve at TH and THTP (see Figure 36, page 16).
Receiver
Terminal
Wires
Battery Clip
Figure 39 - Installing Battery in Receiver
LO
H
I
OFF | L |
| P |
| I |
ON | O |
T |
Figure 40 - Installing Remote Receiver
Installing 9-Volt Battery in Hand- Held Remote Control Unit
1.Remove battery cover on back of re- mote control unit
2.Attach terminal wires to a
3.Replace battery cover onto remote con-
trol unit.
Battery Remote
Terminal | Cover | Control Unit |
| ||
|
| |
Wires |
|
|
Battery
Housing
Figure 41 - Installing Battery in Hand- Held Remote Control Unit (GHRC Series)
Terminal | Remote | |
Control Unit | ||
Wires | ||
|
| Battery |
Battery Housing | Cover |
|
Figure 42 - Installing Battery in Hand-Held Remote Control Unit (GHRCTA Series)
REMOVING/REPLACING GLASS DOOR
You must remove glass door to install logs, lava rock, and ember material. To remove glass door, you must first remove the front panel on stove body.
CAUTION: Do not operate this burner system with a broken glass door panel or without the glass door panel securely in place. For replacement part in- formation see Replacement Parts, page 26.
1.Remove 2 bolts from bottom of stove (if still in place) and one from the top of stove to remove front panel (see Fig- ure 43).
2.Remove the screws from the 2 tabs at the top of the glass door while holding door securely keeping it from falling forward (see Figure 44).
3.Grasp door by both sides and ease it upward off of the lower bracket (see Figure 44).
4.To replace glass door, follow the above instructions in reverse.
Bolt
Bolt
Stove Front Panel
Assembly
Figure 43 - Removing Front Panel from Stove
Screw
Glass Door
Figure 44 - Removing Glass Door from Burner System
Continued
107600 | 17 | For more information, visit www.desatech.com |