Desa FSBVBNC, FSBVBPC installation manual Attaching Stove Legs

CAST IRON STOVE AND BURNER SYSTEM

CAST IRON STOVE AND B-VENT BURNER SYSTEM ASSEMBLY

Continued

9.Attach stove door by inserting step bolt through door hinge pivot hole and into threaded hole in stove body (see Fig- ure 9, page 5 and Figure 11). Use an adjustable wrench or a 12mm socket to fasten step bolt. Tighten step bolt until snug. Make sure door moves freely.

Washers	Bottom Of
Bolt	Stove Unit
	Leg

Figure 10 - Attaching Stove Legs

Stove Door

Panel

Threaded

Hole

Door Hinge

Step

Bolt

Bolt

Shoulder

10.Install door catch bolt (M8 x 1.25-55mm with two M8 hex nuts) into threaded hole on stove body (see Figure 9, page 5). Use an adjustable wrench or a 12mm socket. The catch bolt has two hex nuts attached to it (see Figure 12). The top nut is a bolt stop and the bottom nut is for door leveling adjustment.

11.Check general catch bolt alignment with door claw. Make final adjustment and door leveling after stove is in nor- mal standing position.

12.Carefully lift stove back up on its four attached legs.

13.Remove 2 bolts from bottom of stove and one from the top of the stove to remove the front panel assembly (see Figure 13).

14.Lay the front panel assembly face down on a protected surface. Remove the two screws that hold the front plate onto the front surround plate (see Figure 14). Save these screws.

15.Remove the seven screws and washers that hold the screen onto the front sur- round plate. Discard these screws, washers, and screen. They are for vent- free use only (see Figure 14).

16.Replace the two screws from step 14 to reassemble the front plate and the front surround plate. Set this assembly aside until stove heater has been in- stalled, logs have been placed inside of heater, and glass door to heater insert has been replaced.

17.Remove the two screws that secure the metal plate located across the front sec- tion at the top of the stove body (see Fig- ure 15). Discard these screws and metal plate. They are for vent-free use only.

Bolt

Stop

Adjusting

Nut

Stove

Body Bolt

Front

Assembly

Figure 13 - Removing Front Assembly

Front	Screws
Surround
Plate

Screw with

Washer

Screen

Front Plate

Figure 14 - Removing Screen from Front Assembly

Stove Body

Screw

Figure 11 - Attaching Lower Stove Door Panel

Door Claw

Door

Catch

Bolt

Metal Plate

Figure 12 - Catch Bolt and Door Claw

Orientation

Figure 15 - Removing Metal Plate from

Stove Body

For more information, visit www.desatech.com 6 107600