10
INSTALLATION
WALL SWITCH INSTALLATION
The installation of a wall switch allows you to activate the gas control valve without the normal household electricity since the valve operates on millivolt current supplied by the heat generated by the thermopile. To install the wall switch:
1. | Remove the front refractory access panel by lifting up and |
| angling out of the firebox opening (see Figure 13). |
2. | Use wire and connectors provided. Attach red wire to terminal |
4.Connect wires to control circuit. Connect white wire to termi- nal marked TH/TP on control valve. Connect red wire to male blade connector provided at open end of safety circuit wiring (see Wiring Diagram, page 18).
5.Locate the battery clip mounted on the back of the receiver (see Figure 16).
6.Slide
7.Attach the terminal wires to the battery (see Figure 16).
8.Replace refractory brick access panel.
marked TH/TP on control valve. Attach white wire to blade |
connector on open end of safety circuit wiring (see Wiring |
Diagram, page 18). |
Note: If any of the original wire from the unit control must be re- placed, use the same type or a higher rated wire (25 ft. maximum length).
WARNING: Do not wire remote wall switch to main power supply (Standard 120v household current).
3. | Locate wall switch in a convenient location. |
IN
| ON |
LO | T |
| |
I |
|
P | |
| FFO |
IN | OUT |
To Safety Circuit | Route Millivolt | Wall Switch | |
Wires (Supplied) | (Supplied) | ||
| |||
| Through Gas Line |
| |
| Conduit Sleeve |
| |
| To Thermopile |
| |
TH |
|
| |
TP |
|
| |
THTP |
|
| |
|
| (Back View |
4. | After wire connections are complete, replace refractory access |
| panel. |
Note:Ifanyoftheoriginalwireassuppliedmustbereplaced,use18AWG TYPE CL2 (UL) 105 C (25 ft. length MAXIMUM) or equivalent.
Figure 13 - Removing Front Refractory Access Panel
OPTIONAL WIRELESS
Note: If using optional wireless
Installing Receiver
1.Remove the front refractory access panel by lifting up and angling out of the firebox opening (see Figure 13) to expose controls.
2.Disconnect wall switch wires from TH and TH/TP terminals on control valve (see Figure 14).
3.Install remote receiver unit onto mounting bracket using the two plastic mounting clips (see Figure 15).
Figure 14 - Wall Switch Wiring Diagram
|
| |
Receiver | Battery |
|
|
| |
| Clip |
|
Plastic | Terminal |
|
Mounting |
| |
Wires |
| |
Clips |
| |
|
| |
Mounting Bracket |
| Receiver |
|
| |
Figure 15 - Installing Remote | Figure 16 | - Installing Battery |
Receiver (Shown from Rear of | in Receiver | |
Mounting Bracket) |
|
|
Installing | ||
Control Unit |
|
|
1.Remove battery cover on back of remote control unit.
2.Attach terminal wires to the battery (not included). Place battery into the battery housing. Note: Only use alkaline battery.
3.Replace battery cover onto remote control unit.
Battery Cover | Remote Control Unit |
| |
Terminal Wires |
|
| |
Battery |
|
| Battery |
| Housing |
Figure 17 - Installing Battery in |
For more information, visit www.desatech.com