OWNER’S MANUAL
OPERATING
FIREPLACE
Continued
OPTIONAL REMOTE
OPERATION
Note:Allremotecontrolaccessoriesmust bepurchasedseparately(See Accessories onpage27). Followinstructionsincluded with the remote control.
Thermostat Control Operation
Selector Switch in Remote
Position (GHRC Optional
Remote Control)Control Knob in
On Position
| LO H |
| ON |
| I |
|
|
REMOTE OFF ON |
| T |
|
| L |
| |
|
| O | OFF |
|
| I | |
|
| P |
|
Flame Adjustment Knob
Figure 49 - Setting the (GHRC) Remote Control Selector Switch, Valve Control Knob, and Flame Adjustment Knob for Remote Operation
•In auto mode , the r oom temper a- ture is contr olled b y the ther mo-
stat in the
IMPORTANT: This r emote contr ol has been speciall y eng ineer ed to tak e an air temper ature sample e very 5.5 min utes in auto mode . It will not r e- spond immediately to the tempera-
(OptionalGHRCTOnly)Thethermostat controlsettingontheremotecontrolunit canbesettoanycomfortlevelbetweenHI andLO. Theburnerswillturnonandoff automaticallytomaintainthecomfortlevel you select. The ideal comfort setting will vary by household depending upon the amountofspacetobeheated,theoutputof
Selector Switch in
Remote Position
(GHRCT Optional
Remote Control)
ON
OFF
REMOTE
Control Knob in On Position
O | H |
|
|
L |
| ON | |
| I |
|
|
|
| T |
|
|
| O | OFF |
|
| L |
|
|
| I |
|
|
| P |
|
ture setting being tur ned up or do wn.
IMPORTANT: The
thecentralheatingsystem,etc.
NOTICE: You must light the pilot before using the
1. After lighting , let pilot f lame b urn for |
about one min ute. Turn contr ol knob |
on the contr ol valve to ON position. |
Turn flame adjustment knob an y- |
wher e betw een HI and LO . Slide the |
selector s witch to the REMO TE posi- |
tion. Note: The b urner s ma y light if |
when selector s witch was last tur ned |
off. You can no w turn the b urner s on |
and off with either optional |
remote contr ol unit. |
Flame Adjustment Knob
Figure 50 - Setting the (GHRCT) Selector Switch, control Knob, and Flame Adjustment Knob for Remote Operation
GHRC Series Operation:
2a. Press the ON/OFF b utton to tur n the burner s on and of f. When tur ning burner s off, the pilot will r emain lit.
GHRCT Series Operation:
2b. Select the MAN (man ual) or AUTO button on the
•In man ual mode , turn burner s on
or off by pr essing the ON or OFF buttons on the
3.Use the ST ATUS button on the hand- held r emote contr ol unit to see the operation mode being used and the temper ature setting selected . A red light will come on beside the opera- tion mode being used.
4.To turn the b urner s off when oper at- ingintheman ualmode , presstheOFF button. If oper ating in the auto mode , press the MAN b utton, then pr ess the OFF button. The pilot will r emain lit. IMPORTANT: To turn the pilot of f, manuallyturnthecontr ol knobonthe heater to the OFF position.
IMPORTANT: Do not lea ve the se- |
lector s witch in the REMO TE posi- |
tion when the pilot is not lit. This will |
drain the ba ttery. |
IMPORTANT: Be sur e to pr ess the |
ON/OFF buttons on the |
remote contr ol unit f or up to 3 sec- |
onds to assur e pr oper oper ation. |
Shows Temperature Setting
Allows Burners to be Turned On and Off with the
The Heater will Automatically Cycle Between Pilot and the Heat Setting that has been Selected
HI
TEMP
MAN LO ON
AUTO OFF
STATUS
Increases Room Temperature
Decreases Room Temperature
Turns Burners On and Off
Shows Current Operation Mode
Figure 51 - |
|
(GHRCT Only) | Continued |
106022 | 19 |