SUN VALLEY STOVE COMPANY

B-VENT FREESTANDING FIREPLACE

FREESTANDING FIREPLACE ASSEMBLY

Continued

10.Attach stove door by inserting step bolt through door hinge pivot hole and into threaded hole in stove body (see Fig- ure 9, page 5 and Figure 12). Use an adjustable wrench or a 12mm socket to fasten step bolt. Tighten step bolt until snug. Make sure door moves freely.

11.Install door catch bolt (M8 x 1.25-55mm with two M8 hex nuts) into threaded hole on stove body (see Figure 9, page 5). Use an adjustable wrench or a 12mm socket. The catch bolt has two hex nuts attached to it (see Figure 13). The top nut is a bolt stop and the bottom nut is for door leveling adjustment.

12.Check general catch bolt alignment with door claw. Make final adjustment and door leveling after stove is in nor- mal standing position.

Washers

Bottom Of

Bolt

Stove Unit

Leg

 

Figure 10 - Attaching Stove Legs

13.Carefully lift stove back up on its four attached legs.

14.Remove 2 bolts from bottom of stove and one from the top of the stove to remove the front panel assembly (see Figure 14).

15.Lay the front panel assembly face down on a protected surface. Remove the two screws that hold the front plate onto the front surround plate (see Figure 15). Save these screws.

16.Remove the seven screws and washers that hold the screen onto the front sur- round plate. Discard these screws, washers, and screen. They are for vent- free use only (see Figure 15).

17.Replace the two screws from step 15 to reassemble the front plate and the front surround plate. Set this assembly aside until stove heater has been in- stalled, logs have been placed inside of heater, and glass door to heater insert has been replaced.

Stove

Door

Threaded

Hole

Door

Hinge

Step

Bolt

Bolt Stove

Shoulder Bottom

Figure 12 - Attaching Stove Door

18.Remove the two screws that secure the metal plate located across the front sec- tion at the top of the stove body (see Fig- ure 16). Discard these screws and metal plate. They are for vent-free use only.

19.Set three top grate sections into stove top.

Stove

Bolt

Body

 

Front

 

Assembly

 

Bolts

Figure 14 - Removing Front Assembly

Front

Screws

 

Surround

 

Plate

 

Screw with

Washer

Screen

Front Plate

Figure 15 - Removing Screen from Front Assembly

Screw

Stove

Body

 

Washers

Bolt

Bottom Of

Door Claw

Door

Bolt Stop

Adjusting Nut

Catch Bolt

Metal

Plate

Figure 16 - Removing Metal Plate from Stove Body

Stove Bottom

Stove Unit

Figure 13 - Catch Bolt and Door Claw

Figure 11 - Attaching Stove Bottom

Orientation

6

106022

Page 6
Image 6
Desa MSBVBP, MSBVBN installation manual Set three top grate sections into stove top, Attaching Stove Legs