Desa MSBVBN, MSBVBP Installing Fireplace Into Stove Body, Installing Optional Blower Accessory

OWNER’S MANUAL

FREESTANDING FIREPLACE ASSEMBLY

Continued

INSTALLING FIREPLACE INTO STOVE BODY

1. Attach the two brackets to the back of the stove (see Figure 17). Use the screws and washers from step 4 of Stove Body Assembly on page 5.

2. Carefully lift firebox and place into

stove body from the rear of stove.

3. Using screws provided, attach firebox

1.Remove the two hex head screws on the blower assembly as shown in Figure 18.

2.Place the green wire between the bot- tom hole on the thermal switch bracket and the bottom hole on the blower as- sembly. Insert one of the hex screws into all three pieces and tighten.

3.Insert the top screw through the ther- mal switch bracket and into the blower assembly. Tighten screw.

4.Connect the blue wire on the blower assembly to the right side of the ther- mal switch.

5.Connect the black wire to the left side of the thermal switch.

Black

Installing GA3700/DA3610T Blowers

1.	Align the holes in the top mounting tabs
	of blower with holes in wall of rear
	cover (see Figure 19). Using the 4
	screws provided, mount blower and
	tighten screws securely.
	Note: For DA3610T, make sure the ther-
	mal switch has been properly installed
	to fit against the back of the firebox.
2.	Make sure all wire connections to ter-
	minals on blower motor (and thermal
	switch where applicable) are securely
	attached and that the screw retaining
	the green ground wire is tight.
3.	Place speed control on left inside of rear

to back of stove.

Insert

Assembly

Cast Iron

Stove Body

Screw

Wire	White Wire
	Blower
	Assembly
Thermal	Green
Switch
	Wire
with
	Blue Wire
Bracket
	Hex Head
	Screws

Figure 18 - Attaching Thermal Switch to DA3610T Thermostatically Controlled Blower Accessory

cover and push the plastic control shaft

through opening (see Figure 19).

4. While supporting speed control, secure

control shaft with lock nut by pushing and

turning lock nut with pliers clockwise

until tight against the side of rear cover.

Place control knob provided onto shaft

(see Figure 19).

5. Plug in blower power cord.

6. Check to make sure that the power cord

is completely clear of the blower wheel

and that there are no other foreign ob-

jects in blower wheel. Turn blower on

and check for operation. Turn blower

off by rotating knob fully counterclock-

wise before continuing.

Figure 17 - Installing Firebox Into Cast Iron Stove Body

INSTALLING OPTIONAL BLOWER ACCESSORY

NOTICE: If installing blower in an existing fireplace with gas con- nections, shut off gas supply and disconnect heater from gas sup- ply. Contact a qualified service person to do this.

Attaching Thermal Switch to DA3610T Thermostatically- Controlled Blower

When installing the DA3610T thermostati- cally-controlled blower accessory, you must first secure the thermal switch to the blower.

Blower	Control
Control Knob	Shaft
Lock	Speed Control
Nut	Power Cord

Mounting Screws (Included in Hardware Pack)

White	Black
	Wire	Wiring
Wire
		Diagram
		Decal
Blue		Rear Cover
Wire	Green
	Ground Wire	Blower

Figure 19 - Installing Optional Blower Accessory (Thermostat Model DA3610T Shown)

Continued

106022 7