Desa P)T, P)R Instructions on page, Continued, Manual Lighting Procedure, Thermostat Series Model

Operating Heater

Continued

MANUAL LIGHTING

PROCEDURE

1.Follow steps 1 through 6 under Lighting Instructions, pages 22 and 23.

2.Depress control knob and light pilot with match.

3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11, Lighting Instructions, page 23.

optional Hand-Held

REMOTE OPERATION

Note: All remote control accessories must be purchased separately (see Accessories, page 42). Follow instructions included with the remote control.

To Lock press both buttons on hand-held remote control until light stops flashing. Hand- held remote control is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed.

To Unlock press both buttons together on hand-held remote control until the light stops flashing. The hand-held remote is now unlocked.

Indicator

Light

Control

Button

NOTICE: You must light the pilot

before using the hand-held re-

Figure 34 - On/Off Hand-Held Remote

mote control unit. See Lighting

Control Unit

Instructions on page 22.

Thermostat Series (Model

After lighting, let pilot flame burn for about

HRC200)

one minute. Turn control knob to ON posi-

The hand-held remote can be operated using

tion. Adjust flame adjustment knob anywhere

either the manual mode (MANU) or thermo-

between HI and LO. Slide the selector switch to

static mode (AUTO) (see Figure 35). To select

the REMOTE position (see Figure 33). Note:

Fahrenheit/Centigrade mode display, carefully

The burner may light if hand-held remote was

press the ˚C/˚F mode button with the end of a

on when selector switch was last turned off.

paper clip or similar blunt object.

You can now turn the burner on and off with

the hand-held remote control unit.

Locks

Digital Display Shows

IMPORTANT: Do not leave the selector switch

Temperature and Settings

System to

in the REMOTE or ON position when the pilot

Prevent

Turns

is not lit. This will drain the battery.

Accidental

Hand-Held

Flame Adjustment

ROOM

SET

Ignition

Remote On

Control Knob in

AUTO

Knob

TEMP

TEMP

or Off and

On Position

Allows You

Turns

LOCK

TEMP

POWER

to Choose

OL

Burners

O

N

the Manual

O

FF

O

On or

T

HI

ON

LIP

Setting

REMOTE

ºC/ºF

OFF

Off

MANU

AUTO

Selects

Selector Toggle Switch (Optional

AUTO

Hand-Held Remote Control)

Mode

Figure 33 - Setting the Selector switch,

Increases

Control Knob and Flame Adjustment

or Decreases Room

Knob for Remote Operation

°C/°F Mode

Temperature in

Button

On/Off Series (Model HRC100)

AUTO Mode

Hold the control button on the hand-held remote	Figure 35 - Thermostat Hand-Held
until burner turns on. Hold the control button
	Remote Control Unit
again until burner turns off (see Figure 34).

24 www.desatech.com 119426-01A