VENTING INSTALLATION
Continued
Storm Collar Installation (SC1 or SC2) |
Place storm collar over pipe and slide down until |
it is snug against the open edge of the flashing (see |
Figure 14). Use SC1 for all round terminations and |
14 3/8" Min.
(365 mm)
1" Min.
(25 mm)
1" Min.
(25 mm)
30" Min.
(762 mm)
1" Min.
(25 mm)
SC2 for all terminations with slip sections. Apply | |
waterproof caulk around the perimeter of the collar | |
to provide a proper seal. |
|
Chimney | Waterproof |
Pipe | Caulk |
Storm | Flashing |
Collar |
Opening "A"
Pitch | Slope | Opening "A" | Used Flashing | |
|
| Max. | Model No. | |
Flat | 0° | 15" | ||
26.6° | 16 1/8" | |||
6/12- | 45.0° | 20 3/8" | ||
12/12 | ||||
|
|
|
Figure 12 - Roof Opening Measurements
FLASHING INSTALLATION
Determine the flashing to be used with the roof opening chart. Slide flashing over pipe until base is flat against roof. Replace as many shingles as needed to cover exposed area and flashing base. Secure in position by nailing through shingles (see Figure 13). DO NOT NAIL THROUGH FLASHING CONE.
Installing Flashing on a Metal Roof
When installing the flashing on a metal roof, it is required that putty tape be used between the flashing and the roof. The flashing must be secured to the roof
Figure 14 - Storm Collar
Terminations/Spark Arrestor The fireplace system must be terminated with the listed round top or chase terminations. In any case, refer to the installation instructions supplied with the termination. The termination approved for this fireplace are the
CAUTION: Do not seal open- ings on the rooftop flashing. Fol- low the installation instructions provided with the termination being used.
using #8 x 3/4" screws and then sealed with roof coat- ing to prevent leakage through the screw holes.Aroof coating must also be applied around the perimeter of the flashing to provide a proper seal.
Attach Bracket Tabs to Outer Pipe (3 Places) Secure with
Level of
Flue Gas
Outlet
Storm Collar
Flashing
Cone
Nail Only
Outer
Perimeter
of Flashing
Overlap
Shingles Top
and Sides Only
Screws
Overlap
Shingles Top
and Sides
Caulk
Collar
Flashing
Underlap Shingles at Bottom
Underlap
Shingles
Bottom Only
Figure 13 - Flashing Installation
Figure 15 - Termination
www.desatech.com | 9 |