OPERATING STOVE AND BURNER SYSTEM
Manual Lighting Procedure
Optional Remote Operation
27
OPERATING STOVE WITH BURNER SYSTEM
Continued
MANUAL LIGHTING
PROCEDURE
1.Remove glass door (see Removing/Replacing Glass Door, page 24).
2.Follow steps 1 through 8 under Lighting Instructions, page 26.
3.Depress gas control knob and light pilot with match.
4.Keep gas control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release gas control knob. Now follow steps 10 through 14 under Lighting Instructions, page 26.
5.Replace glass door (see Removing/Replacing Glass Door, page 24).
OPTIONAL REMOTE
OPERATION
Note: All remote control accessories must be purchased sepa- rately (See Accessories on page 38). Follow instructions in- cluded with the remote control.
Thermostat Control Operation
(Optional GHRCTA Only) The thermostat control setting on the remote control unit can be set to any comfort level between WARMER and COOLER. The burners will turn on and off automatically to maintain the comfort level you select. The ideal comfort setting will vary by household depending upon the amount of space to be heated, the output of the central heating system, etc.
NOTICE: You must light the pilot before using the
1. After lighting, let pilot flame burn for about one minute. |
Turn gas control knob on the control valve to ON position. |
Turn variable control knob anywhere between HI and LO. |
Slide the selector switch to the REMOTE position. Note: |
GHRCTA Series Operation:
2b. Press the AUTO/ON/OFF button on the
•In the ON mode, the burners will ignite. The heater is in manual mode when ON is lit.
•In the AUTO mode, the thermostat in the
IMPORTANT: This remote control has been specially en- gineered to take an air temperature sample every 5.5 min- utes in the auto mode. It will not respond immediately to the temperature setting being turned up or down.
IMPORTANT: The
3.To turn the burner off, press the AUTO/ON/OFF button un- til OFF lights. The pilot will remain lit.
IMPORTANT: To turn the pilot off, manually turn the con- trol knob on the heater to the OFF position.
Selector Switch in Remote | Gas Control Knob | Variable | |||||||||||
Position (Optional Remote | |||||||||||||
in On Position | Control Knob | ||||||||||||
Control) | |||||||||||||
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
| |
LO
IN OUT
Figure 61 - Setting the Selector Switch, Gas Control Knob, and Variable Control Knob for Remote Operation
The burners may light if |
on when selector switch was last turned off. You can now |
turn the burners on and off with either optional |
remote control unit. |
IMPORTANT: Do not leave the selector switch in the REMOTE |
position when the pilot is not lit. This will drain the battery. |
IMPORTANT: Be sure to press the ON/OFF buttons on the |
proper operation. |
GHRC Series Operation:
Shows Temperature Setting
The Log Heater will Automatically Cycle between Pilot and the Heat Setting that has been Selected
Increases Room
Temperature in
AUTO Mode
Decreases Room
Temperature in
AUTO Mode
Turns Burner On or Off and Allows You to Choose the Auto Setting
2a. Press the ON/OFF button to turn the burners on and off. When turning burners off, the pilot will remain lit.
Figure 62 - Hand-Held Thermostat Remote Control Unit Selections (GHRCTA Only)
For more
visit www.
.com
