SAFETY INFORMATION PRODUCT IDENTIFICATION
3
SAFETY INFORMATION
Continued
6.Carefully supervise young children when they are in the room with stove.
7.Do not modify the burner or stove under any circumstances. Any parts removed for servicing must be replaced prior to operating stove or burner system.
8.Turn burner system off and let cool before servicing, install- ing, or repairing. Only a qualified service person should in- stall, service, or repair the stove or burner system. Have burner system inspected annually by a qualified service person.
9.You must keep control compartments, burners, and circulat- ing air passages clean. More frequent cleaning may be needed due to excessive lint and dust from carpeting, bedding mate- rial, pet hair, etc. Turn off the gas valve and pilot light before cleaning stove or burner system.
10.Have venting system inspected annually by a qualified service person. If needed, have venting system cleaned or repaired. See Cleaning and Maintenance, page 29.
11.Keep the area around your stove clear of combustible materi- als, gasoline, and other flammable vapor and liquids. Do not run burner system where these are used or stored. Do not place items such as clothing or decorations on or around stove.
12.Do not use this stove to cook food or burn paper or other objects.
13.Never place anything on top of stove.
14.Do not use any solid fuels (wood, coal, paper, cardboard, etc.) in this stove. Use only the gas type indicated on burner system nameplate.
15.This appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Ca- nadian Electrical Code, CSA C22.1.
16.Do not obstruct the flow of combustion and ventilation air in any way. Provide adequate clearances around air openings into the combustion chamber along with adequate accessibility clearance for servicing and proper operation.
17.Do not install stove directly on carpeting, vinyl tile, or any com- bustible material other than wood. The stove must set on a metal or wood panel extending the full width and depth of the stove.
18.Do not use stove or burner system if any part has been ex- posed to or under water. Immediately call a qualified service person to arrange for replacement of the unit.
19.Do not operate burner system if any log is broken.
20.Do not use a blower insert, heat exchanger insert, or other ac- cessory not approved for use with this stove.
21.Do not operate burner system with glass door removed, cracked, or broken.
22.Provide adequate clearances to air openings.
PRODUCT IDENTIFICATION
Cast Iron
Stove Body
Log Set
| OT |
O |
|
IN | OUT |
Piezo Ignitor | Control Valve |
Vent | Cast Iron | |
Stove Body | ||
Opening |
| |
Rear |
| |
Cover |
| |
ON/OFF |
| |
Switch |
| |
(Other |
| |
Side) |
| |
Pilot | Burner | |
Glass | ||
Assy | ||
| Door Assy | |
Blower with | Lava Rock | |
Adjustment | ||
| ||
Knob (Optional |
| |
Installation) |
|
Glowing | Grate Assembly | |
Embers | ||
|
Figure 1 - DESA Direct-Vent Burner System Shown Installed in Approved Cast Iron Stove Body (Vanguard Models SCIVFC/ PSCIVFC Series Shown)
For more
visit www.
.com
