INSTALLATION
Continued
5.Center cabinet mantel on hearth base (see Figure 12). Make sure mantel is flush against wall and centered left to right on base.
6.Use screws provided with mantel accessory to attach mantel assembly to base (see mantel instruction sheet).
7.Attach flexible gas line to fireplace gas regula- tor. See Connecting to Gas Supply, page 16.
8.Route electrical cord(s) through access holes in either side of fireplace with bushing. Plug electrical cord(s) into electrical outlet.
9.Check all gas connections for leaks. See
Checking Gas Connections, page 17.
10.Carefully insert fireplace into cabinet mantel (see Figure 13). Be careful not to scratch or damage hearth base or cabinet mantel.
11.Place metal trim on shoulder screws located on the side and top of the fireplace (see Assem- bling Perimeter Trim). Firmly snap trim over shoulder screws. Align fireplace in mantel assembly so the trim overlaps mantel evenly on all three sides.
12.Lower bottom louver door. Use 3" wood screws provided with mantel accessory to at- tach fireplace to base (see mantel instruction sheet).
Cabinet
Mantel 
Hearth
Base
Cabinet
Mantel
Assembled
Trim
Hearth Base
Figure 13 - Installing Fireplace into
Mantel Assembly
Assembling Perimeter Trim (Perimeter
trim shipped with mantel)
1. Remove packaging from three remaining pieces of trim.
2. Locate two adjusting plates with set screws and two shims in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 14.
4. Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 14).
5. Slide other end of adjusting plate/shim in slot on mitered edge of side perimeter trim (see Figure 14).
6. While firmly holding edges of perimeter trim together, tighten both set screws on the adjust- ing plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other corner.
8. Set perimeter trim assembly aside for later installation.
Adjusting Plate
Set Screws
Figure 12 - Installing Cabinet Mantel onto
Hearth Base
Slot | Top Trim |
Shim | Mitered Edge |
|
Side Trim 
Figure 14 - Assembling Perimeter Trim
Installing Optional Blower Accessory GA3450TA
Removing Upper Louver
To install the blower accessory, you must first remove the upper louver.
1.Lift screen off fireplace and remove log set if installed.
www.desatech.com | 13 |
