Desa VDCFTNA installation manual Optional Hand-Held, Remote Operation, On/Off Series Model HRC100

OPERATING FIREPLACE

Continued

optional Hand-Held

REMOTE OPERATION

Note: All remote control accessories must be purchased separately (see Accessories, page 40). Follow instructions included with the remote control.

NOTICE: You must light the pilot before using the hand-held re- mote control unit. See Lighting Instructions on page 23.

1.After lighting, let pilot flame burn for about one minute. Turn control knob to

ON position. Adjust flame adjustment knob anywhere between HI and LO. Slide the selector switch to the REMOTE position (see Figure 43). Note: The burner may light if hand-held remote was on when selector switch was last turned off. You can now turn the burner on and off with the hand- held remote control unit.

IMPORTANT:Do not leave the selectorswitch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

FlameControl

Adjustment Knob Knob

Selector Switch in Remote Position (Optional Remote Control)

Figure 43 - Setting the Selector Switch,

Control Knob and Flame Adjustment

Knob for Remote Operation

On/Off Series (Model HRC100)

Hold the control button on the hand-held remote until burner turns on. Hold the control button again until burner turns off (see Figure 44).

To Lock press both buttons on hand-held remote control until light stops flashing. Hand- held remote control is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed.

To Unlock press both buttons together on hand-held remote control until the light stops flashing. The hand-held remote is now unlocked.

Control

Indicator Button

Light

Figure 44 - On/Off Hand-Held Remote

Control Unit

Thermostat Series (Model HRC200)

The hand-held remote can be operated using either the manual mode (MANU) or thermo- static mode (AUTO) (see Figure 45). To select Fahrenheit/Centigrade mode display, carefully press the ˚C/˚F mode button with the end of a paper clip or similar blunt object.

Manual Mode

1. Press the POWER and LOCK buttons togeth- er to turn on the hand-held remote control.

2. Press the MANU button to turn on the fireplace.

3. Press the POWER and LOCK buttons together to turn off the fireplace.

Auto (Thermostatic) Mode

1. Press the POWER and LOCK buttons together to turn on the hand-held remote control.

2. Press AUTO button to select this mode.

3. Set the desired room temperature by press- ing the TEMP + or - buttons.

4. Press the POWER and LOCK buttons together to turn off the fireplace.

				Digital
Locks		AUTO		Display
	ROOM		SET	Shows
System to	TEMP		TEMP
				Temperature
Prevent
		TEMP		and Settings
Accidental	LOCK		POWER
Ignition
Turns	MANU	ºC/ºF	AUTO
Burners				Turns
				Hand-Held
On or
				Remote On
Off
				or Off and
Increases				Allows You
				to Choose
or Decreases
	°C/°F			the Manual
Room			Selects
				Setting
Temperature	Mode		AUTO
in AUTO Mode	Button		Mode

Figure 45 - Thermostat Hand-Held

Remote Control Unit

113133-01C www.desatech.com 25