INSTALLATION
Optional Wireless
17
INSTALLATION
Continued
OPTIONAL WIRELESS
Note: If using an optional wireless
NOTICE: Only use alkaline batteries (not included).
Installing Receiver
1.Remove access panel from lower front face of firebox. Lift straight up on access panel until it stops. Pull bottom of access panel forward, then down.
2.Disconnect wall switch wires from TH and TPTH terminals on control valve (see Figure 33).
3.Install remote receiver unit onto mounting bracket using the two plastic mounting clips (see Figure 35).
4.Connect wires to control valve. Connect white wire to termi- nal TH. Connect red wire to terminal TPTH.
5.Locate the battery clip mounted on the back of the receiver (see Figure 36).
6.Slide
7.Attach the terminal wires to the battery (see Figure 36).
8.Replace access panel. Place top of access panel into opening and slide up. Push bottom of access panel in and slide down to install.
| Plastic |
Receiver | Mounting |
Clips | |
| Mounting |
| Bracket |
Figure 35 - Installing Remote Receiver (Shown from Rear of Mounting Bracket)
Battery Clip
Receiver
Installing
1.Remove battery cover on back of remote control unit.
2.Attach terminal wires to the battery (not included). Place bat- tery into the battery housing.
3.Replace battery cover onto remote control unit.
Terminal Wires | Battery Cover |
Remote Control
Battery
Battery
Housing
Figure 37 - Installing Battery in
Terminal Wires
Figure 36 - Installing Battery in Receiver
For morevisit www..com