Desa VDDVF36PN/PP Wall Switch Installation, Electrical Hookup for Blower Accessory

16

VENTING INSTALLATION

Parts Lists For Venting Kits And Components (Cont.)

INSTALLATION

Wall Switch Installation

Electrical Hookup For Blower Accessory

VENTING INSTALLATION

Continued

PARTS LISTS FOR VENTING KITS AND COMPONENTS (Cont.)

DESA International Venting Accessories

Number Description

SC-47 Galvanized Storm Collar

WF-47 Galvanized Wall Firestop

RF-47-6 Galvanized Roof Flashing, 0 to 6/12 Pitch RF-47-12 Galvanized Roof Flashing, 6/12 to 12/12 Pitch VR-47 Galvanized Vertical Restrictor

S-47 Galvanized Combustible Siding Standoff WS-47 Wall Strap

FP-47 Firestop Plate

PA-47-6 Galvanized 6" Pipe Adaptor (Required)

INSTALLATION

WALL SWITCH INSTALLATION

Since the VDDVF36 series models use a valve that operates on millivolt current generated by the pilot, a wall switch (not included) may be used to activate the gas control valve without the use of normal household electricity.

1.To remove the louvers, simultaneously pull both top end spring latches towards the center of the appliance until they are dis- engaged from locating holes. Repeat for bottom end spring latches and pull outward. Reverse the procedure to install lou- vers back onto the appliance (see Figure 32).

2.Connect the 18 ga. wires from wall switch (not included) to the gas control valve and microswitch, as shown in Figure 33.

WARNING: Do not wire remote wall switch to main power supply (Standard 120v household current).

Glass

Locating

Holes

Spring

Latch

Figure 32 - Removing Louver

Wall Switch

(Supplied)

To Thermopile

			IL	O
				T
			P
	N		16AI
	O
O	T				TH
L				7
I
P		L	I
	FFO	O
			H		TP
	E	A			TPTH

Route Millivolt Wires	(Back View)
(Supplied) Through Gas
Line Conduit Sleeve

Figure 33 - Wall Switch Wiring Diagram

Note: If any of the original wire supplied must be replaced, use type 18 AWG-105 degree C (25 feet length MAXIMUM) or equivalent.

ELECTRICAL HOOKUP FOR BLOWER ACCESSORY

Before blower accessory can be operated, it must be properly connected to a standard 120 VAC power source. Refer to Wiring Diagram on page 28.

An outlet box with two receptacles has been supplied for your convenience, located on the lower left side of the appliance (see Figure 34). An optional remote control may be installed at any time.

CAUTION: Due to high temperatures, make sure no wires are touching the bottom of the firebox.

For Optional

Fan Kit

From Blower

Assembly

Figure 34 - Connecting Blower Accessory to Power Supply

For..com

106918-01B