DeWalt 36-L31X, 36-L53L, 36-L51X, 36-L51L instruction manual

A

F

Fig. 12

5.To adjust, loosen the two screws (F) Fig. 12. Adjust the splitter bracket (A) until it is aligned with the inside blade flange (B) Fig. 11. Tighten the two screws (F). Loosely attach the screw and fastener plate that were removed earlier.

6.Insert the threaded end of the support rod (G) Fig. 13 through the slot in the rear of the saw and into hole in the rear trunnion (H). Fasten the support rod (G) to the trunnion with a star washer and a 5/8-18 hex jam nut (J) Fig. 14.

NOTE: Thread the nut (J) Fig. 14 on the threads of the support rod (G) as far as possible by hand.

7.Use a wrench to hold the jam nut (J) Fig. 14. Tighten the rod (G) Fig. 15 with a small screwdriver (K) or similar device through the hole in the end of the rod.

8.Loosely attach the lower bracket (L) Fig. 16 to the rod

(G)with two 5/16-18 x 1” hex-head screws (S) and 5/16” lockwashers (T) from underneath the bracket (L).

9.Align the hole in the upper splitter bracket (M) Fig. 17 with the hole in the lower splitter bracket (L). Place a 5/16” lockwasher, then a 5/16” flat washer on a 5/16-18 x 1” hex-head screw (N). Insert the screw (N) through the hole in the upper splitter bracket (M) and thread the screw in the lower splitter bracket (L).

NOTE: Loosely tighten the screw (N) for further adjustment.

G

H

Fig. 13

J

Fig. 14

K

G

Fig. 15

N

T

S

L

G

T

Fig. 16

M

L

Fig. 17

11