DeWalt DCN692, DCN690 Application, Make sure to tighten magazine hex bolts with wrench provided

English

SYMPTOM	CAUSE	FIX
Tool operates but does not drive fasteners fully	Depth adjust set too shallow	Rotate depth adjust to a deeper setting.
	Tool not fi rmly applied to workpiece	Apply adequate force to tool securing it tightly to workpiece See instruction
		manual.
	Material and fastener length	If the unit continues to stall (forcing the need to rotate the Stall release lever)
		choose the appropriate material and fastener length that is not too rigorous of an
		application.
	Damaged or worn driver blade tip	Replace driver/return assembly See authorized service center.
	Damaged actuation mechanism	See authorized service center.
Tool operates, but no fastener is driven	No nails in magazine	Load nails in magazine.
	Wrong size or angle nails	Use only the recommended nails Refer to Nail Specifications.
	Debris in nosepiece	Clean nose area and watch closely for small pieces of broken nails stuck in the
		track.
	Debris in magazine	Clean magazine
	Worn magazine	Replace magazine See authorized service center.
	Damaged or worn driver blade	Replace driver blade See authorized service center.
	Damaged pusher spring	Replace spring; see authorized service center.
Jammed nail	Wrong size or angle nails	Use only the recommended nails Refer to Nail Specifications.
	Magazine screws not secured after previous jam clear/inspection	Make sure to tighten magazine hex bolts with wrench provided.
	Damaged or worn driver blade	Replace driver blade See authorized service center.
	Material and fastener length	If the unit continues to stall (forcing the need to rotate the Stall release lever)
		choose the appropriate material and fastener length that is not too rigorous an
		application.
	Debris in nosepiece	Clean nose area and watch closely for small pieces of broken nails stuck in the
		track.
	Worn magazine	Replace magazine See authorized service center.
	Damaged pusher spring	Replace spring; see authorized service center.

14