3.Loosen the locking lever (E) Fig.5 and insert the tool rest (F) in the tool rest base.

NOTE: To adjust the height of the tool rest, loosen the loching lever (E). After adjustment, tighten the locking lever.

ATTACHING THE TAILSTOCK TO THE LATHE BED

F

Fig. 5

E

1.Loosen the locking lever (A) Fig. 6, and slide the tailstock assembly (B) Fig. 7 in the channel (C) of the lathe bed.

2.IMPORTANT: If the clamping action on the tailstock (B) Fig. 7 is too tight or too loose on the lathe bed, remove the tailstock and turn the nut (D) Fig. 7 clockwise to tighten the clamping action, or counter-clockwise to loosen the clamping action. Attach the tailstock on the lathe bed and tighten locking lever (A) Fig. 6.

A

B

D

Fig. 6

Fig. 7

C

ATTACHING THE HEADSTOCK SPUR CENTER TO THE LATHE

1.The supplied spur center (A) Fig. 8 is equipped with a No. 2 Morse Tapered shank (B). It will fit snugly into the head- stock spindle.

NOTE: Before inserting, clean both the shank and the headstock spindle to remove grease or debris.

2.Use the knockout bar (C) Fig. 9 through the hole in the opposite end of the spindle to remove the spur center (A). Be careful of the sharp points on the shank spur center.

A

C

Fig. 8

A

B

Fig. 9

8

Page 8
Image 8
DeWalt LA200 instruction manual Attaching the Tailstock to the Lathe BED, Attaching the Headstock Spur Center to the Lathe