Single port KVM over IP switch
• Force Composite Sync (Required for Sun Computers)
To support signal transmission from a Sun machine, enable this option. If not enabled
the picture of the remote console will not be visible.
To set the options, click on the button “ Apply ” .
6.5 Device Settings
6.5.1 Network
The Network Settings panel as shown in Figure 6-19 allows changing network related
parameters. Each parameter will be explained below. Once applied the new network settings
will immediately come into effect.
Figure 6-19. Network Settings
Warning
The initial IP configuration is usually done directly at the host system using the
special procedure described in Table 4-1 .
Warning
Changing the network settings of the IP-KVM switch might result in losing connection
to it. In case you change the settings remotely make sure that all the values are
correct and you still have an option to access the IP-KVM switch.
IP auto configuration
With this option you can control if the IP-KVM switch should fetch its network settings
from a DHCP or BOOTP server. For DHCP, select “ dhcp ” , and for BOOTP select
“ bootp ” accordingly. If you choose “ none ” then IP auto configuration is disabled.
IP address
IP address in the usual dot notation.