RESET button | LAN port |
| SIM Card slot |
| |
|
| (for Vega Wireless Camera GPRS) |
| ||
|
| ||||
|
|
|
|
| |
|
|
|
|
| |
PWR LED |
|
| INPUT clamp strip |
| |
|
|
|
|
|
|
SIGNAL LED
PWR connector | Antenna connector |
2.3a LED DESCRIPTION (VEGA WIRELESS CAMERA WLAN)
Three LED options indicate a different camera status, as follows:
•PWR: Vega Wireless Camera’s power
•SIGNAL: information on WLAN connection
•STATUS: information on remote connection
The LEDs can act as follows:
|
| PWR |
|
| SIGNAL |
|
| STATUS | |
| OFF | Camera is OFF |
| OFF | WLAN unit is OFF |
| OFF |
| Image capture is |
|
|
|
| OFF | |||||
|
|
|
|
|
|
|
|
| |
| Blinking | - |
| Blinking | - |
| Blinking |
| - |
| ON | Camera is ON |
| ON | WLAN unit is ON |
| ON |
| Image capture is |
|
|
|
| ON | |||||
|
|
|
|
|
|
|
|
| |
When the Vega Wireless Camera WLAN is powered, the device goes through the following stages:
1.Vega Wireless Camera’s power: PWR LED is ON;
2.Start of the Operating System: LED is steady ON for about 30 seconds;
3.Status LED steady ON for about 10 seconds;
4.WLAN unit identification: Status LED turns OFF and SIGNAL LED turns ON in the rear panel. In case of problems with the WLAN unit, the Status LED will blink for about 10 seconds and the Vega Wireless Camera can be used only through the LAN port.
5.Start of the image capture after about 2 minutes: Status LED is ON.
2.3b LED DESCRIPTION (VEGA WIRELESS CAMERA GPRS)
Three LED options indicate a different camera status, as follows:
•PWR: Vega Wireless Camera’s power
•SIGNAL: information on GSM network
•STATUS: information on remote connection
16