3.3.2 WiFi (only for the VEGA WIRELESS CAMERA WLAN)

In this window you may change the parameters of the WLAN interface to be found on both Vega Wireless Camera versions.

In order to communicate via wireless LAN with the Vega Wireless Camera WLAN you need to use an Access Point. For a correct communication with the camera you then need to set all values for this window.

IP Address: insert the IP address the camera will use for wireless transmission on the LAN port.

WARNING: the IP address of the WLAN interface must belong to another network than the IP address of the LAN interface.

After changing the IP address of the Vega Wireless Camera, switch off the device and switch on after 10 seconds. You may be asked to modify also the IP address of the computer, in order to proceed with the camera configuration.

Channel: this drop-down menu provides the wireless communication channel. A "channel" is a range of frequencies to use for the communication between the camera and the Access Point. Select the channel in order for it to correspond with the value set in the Access Point. The default setting is Channel 1.

SSID: Service Set Identifier, is the name assigned to the wireless network. To connect the camera to a specific access point on the network, please make sure to set the SSID of the camera to correspond with the access point’s SSID for communication. Type any string up to 32 characters long (spaces, symbols and punctuation are not allowed).

26