2.6 INSTALLING THE EXTERNAL ANTENNA
To install the external antenna follow these steps:
Make sure that the Vega Wireless Camera is off by turning off the power supply and deactivating the backup battery in the configuration pages.
Connect the external antenna connector to the Vega Wireless Camera’s connector by screwing it clockwise. In case of problems do not force the connector and check if it is right positioned.
In the configuration pages you are able to test the GSM signal quality and the presence of GPRS recording (for the Vega Wireless Camera GPRS) or the connection to the Access Point (for the Vega Wireless Camera WLAN).
Sometimes the stylus antenna supplied with the device may not be alone sufficient to guarantee the correct functioning of the system. This can be due to a poor GSM coverage in the installation place (for the Vega Wireless Camera GPRS) or to interferences in the installation place (for the Vega Wireless Camera WLAN). For this reason we suggest to check the accessories available for the two Vega Wireless Camera models, in order to get the best results for your installation.
2.7 POWER SUPPLY
Power the Vega Wireless Camera with the power adapter supplied in the package. For your information keep the following power supply details of the camera: 12Vdc – 1000 mA.
+12 V CC
GND
2.8RESET BUTTON
In the Vega Wireless Camera’s rear panel you find the Reset button. To access the Reset button you may use a sharpen object, like a pencil or a paper clip.
To reset the device back to factory settings hold the button for 2 seconds; when the Status LED in the front panel turns on you can release the button.
To reboot the camera hold the reset button for at least 7 seconds.
20