3.When you see the control bar, this means that you have successfully logged into the program on the Video Web Server. Click on “System Config” to set up.(NOTE: If you don’t connect a camera or DVR to the Video Web Server, the only thing you will see is the control bar.)
SYSTEM CONFIG
4.In the Peripheral setting, set the baud rate, ID and model that you want to remotely control later. Press the “APPLY” to enable the change after the setting.
5.Click on “System Config” again. In the Network setting, set the server IP, gateway, net mask and DNS provided from your local ISP (internet service provider). Press “APPLY” to enable the change after the setting.
