Dimension One Spas 01513-192 manual Programming the Filtration Cycle, LED Display Window

Aquatic Fitness System

2005 Owner’s Manual

LED Display Window

LED Display Window: This window displays the actual water temperature. However when you are setting the “target temperature” for your water, this window will display the SET temperature. After a brief pause, about 5 seconds, the window will return the display to the actual water temperature.

Programming the Filtration Cycle

Filtration

Proper filtration is an important key to maintaining the clarity of your spa’s water. The filter system is designed for unsurpassed effectiveness at removing debris and suspensions from the water anytime the water is circulating.

The Aquatic Fitness System comes with six pre-programmed filtration cycles (F1-F6) and two lockout (L1 & L2) modes. Of the six filter cycles, three cycles are in the standard mode and three cycles are in the economy mode.

To change the filter cycle or to enable or disable a lockout mode, press and hold both the WARMER and the COOLER buttons for 3 seconds. This enters the programming mode and allows you to select your filtration cycle. The display will show F1 through L2. The current filter setting

will be displayed in the window.

Use the WARMER and COOLER buttons to scroll up or down between the filtering modes. The filter cycles are as follows:

•Standard Mode: F1, F2, F3

•Economy Mode: F4, F5, F6

•Lockout Mode: L1, L2

Standard Mode and Economy Mode are used primarily to determine how to heat your water. When you select a filter cycle of F1, F2, or F3, you are selecting Standard Mode. In Standard Mode the temperature of the water is used to determine the need for heat. Whenever the temperature of the water drops to 2°F (≅1.1°C) below your SET temperature, the pump will start and the water will heat until the water is 2°F (≅1.1°C) above your SET temperature. In Standard Mode, heating the water is independent of the filter cycles.

When you select a filter cycle of F4, F5, or F6, you are selecting Economy Mode. In Economy Mode, the water only heats when the filter us running. In Economy Mode, heating the water is dependent on the filter cycle.

When you select options L1, or L2, you are selecting the Lockout Mode, which allows you to suspend filter operation or control unauthorized access to your system.

16