Dimension One Spas 2000 Model Instructions For Your Spa, Positioning Your Spa, Safety Devices

2000 Owner’s Manual

13

INSTRUCTIONS FOR YOUR SPA

BEFORE ATTEMPTING TO HOOK-UP OR USE YOUR SPA, PLEASE READ THROUGH THESE INSTRUCTIONS AND CAREFULLY VIEW YOUR VIDEO OWNER’S MANUAL.

POSITIONING YOUR SPA

Because your spa is completely self-contained, you can locate it just about anywhere you wish... on a deck, patio or even indoors. Just be sure to position it above ground, in an area with good drainage, and on a level, continuous surface that contacts the bottom of the spa fully. A concrete slab is best but not required. Locate your spa so that the equip- ment is above grade and not subject to flooding. WATER SHOULD

ALWAYS DRAIN A WAY FROM THE SPA.

SAFETY DEVICES

Your spa is equipped with the following safety features:

1)A water flow sensor that prevents the heater from activating unless there is sufficient water flow, thus preventing “dry firing” of the heater.

2)Automatic spa shutdown timers that shut off the spa jet pump after 30 minutes of operation. The Chairman II, Diplomat, Chairman, Californian, Nautilus, Aurora II and Triad II can be programmed to shut off after longer intervals (I.E. 45, 60 minutes). The spa light automatically shuts off after 1 hour.

3)An electronic high limit switch that automatically shuts off the heater if the spa water temperature exceeds 112˚ F.

4)An automatic freeze sensor which puts the spa into ‘Smart Winter Mode’ if the air temperature in the equipment bay drops below a facto- ry preset level. In ‘Smart Winter Mode’, your spa will start the jets for 1 minute, at high speed, every two hours, for 24 hours.