2000 Owner’s Manual
20
TEMPERATURE PADS
Pushing the UP pad increases the temperature and pushing the DOWN pad decreases the temperature. Push the respective pad one time for each degree of temperature change, or push and hold the pad for rapid adjustment. The existing spa water temperature will remain in the digi- tal display window until a temperature pad is pushed. When the UP or DOWN pad is pushed the digital readout will indicate the new tempera- ture setting, with the SET POINT Icon on the right side of the display. Once the new temperature is set, the current spa water temperature will again be indicated. The spa will heat to the
LIGHT
Push the LIGHT control pad once to activate the brightest setting. A second push will activate the medium setting and a third push will acti- vate the dimmest setting. The light icon and LED on the display will come on when the light is activated. Push the LIGHT control pad a fourth time to turn off the light. The light will automatically turn off after a factory
PROGRAMMING THE PROGRAMMABLE DIGITAL CONTROL
To initiate the programming sequence at any time, push and hold the PROGRAM pad for 3 seconds. If, within 10 seconds, you do not pro- ceed with the spa programming, the spa will automatically exit the pro- gramming sequence and revert to the
CLOCK SET
Push and hold the PROGRAM pad for 3 seconds to engage the time set- ting mode. The time screen will appear with “hours” (_ _.00) flashing on and off. Push the UP or DOWN pad to increase or decrease the number until the desired hour appears. When the desired number is displayed, push the LIGHT pad to accept the selection and change the flashing number to the “ten minute” place (12:_0). Adjust the number with the UP or DOWN pad in the same manner as the hour number.
