2000 Owner’s Manual
17
INITIAL
1)Before filling your spa, install the hose bib that is included in the owner’s manual packet located in the equipment compartment. Screw the hose bib onto the male fitting located at the bottom of the spa on the pedestal, to the lower left of the equipment compartment. Close the valve on the side of the hose bib and screw the cap onto the end of the hose bib.
2)Check the pump unions to be sure that they are tight to prevent the possibility of leakage in the equipment compartment. Also, open the bleeder valve located next to the sidewall of the skimmer area to allow air to escape from the pump(s).
3)Fill your spa with water to a level of one to two inches above the bottom of the tile line.
4)Remove the two shipping bolts located on the front of the pump mount and ensure that the gate valves on the pump are in the open position (handles fully extended).
5)Turn on the circuit breaker. Dashed lines will appear for 30 seconds on the LCD followed by the current water temperature flashing. Press the UP or DOWN pads to set your desired spa temperature. If your spa is equipped with the CrystalZone Water Management System and there is a call for heat, the circulation pump will then activate and turn on the heater. If CrystalZone is not installed, and there is a call for heat, the low speed pump will come on with the heater. One minute after
