Dimension One Spas 2000 Model Programming The Scrolling Message Cen - Ter, Liquid Crystal Display

2000 Owner’s Manual

28

LIQUID CRYSTAL DISPLAY:

The LCD continuously shows the operating status of the spa, as well as the various monitoring functions, self-diagnostics, and programming information.

PROGRAMMING THE SCROLLING MESSAGE CEN - TER:

Your Scrolling Message Center is the most advanced in the industry and can virtually walk you through customizing your spa to your exact needs.

To initiate the programming sequence at any time, push and hold the PROGRAM pad for 3 seconds. If, within 10 seconds, you do not pro- ceed with the spa programming, the spa will automatically exit the pro- gramming sequence and revert to the pre-set factory default settings. To exit the programming sequence at any time, push the ENTER pad or do not press a pad for 10 seconds. Any programming changes made up to that point will be saved.

SETTING THE TIME:

After holding the PROGRAM pad, the top line of the LCD will read “SET TIME OF DAY” and the bottom line will read “PUSH UP OR DOWN TO CHANGE - PUSH PROGRAM TO SELECT NEXT FUNCTION - PUSH ENTER TO EXIT ”. Push the UP or DOWN pads to engage the time setting mode. The time screen will appear with “hours” (_ _.00) flashing on and off. Push the UP or DOWN pad to increase or decrease the number until the desired hour appears. When the desired number is displayed, push the LIGHT pad to accept the selection and change the flashing number to the “ten minute” place (12:_0). Adjust the number with the UP or DOWN pad in the same manner as the hour number. When the desired indicator is displayed, push the LIGHT pad to accept the selection and change the flashing number to the “minute” place (12:1_). Adjust this number with the UP or DOWN pad in the same manner as the hour number. When the desired number is displayed, push the LIGHT pad to accept the selection and change the flashing number to a flashing AM or PM indicator. Adjust the indicator with the UP or DOWN pads. After reaching the correct time, push the PROGRAM pad to set the time and exit the time-setting mode. You will then be prompted to set the filter start time.