Dimplex DF3215 manual Maintenance, Light Bulb Replacement, Lower Light Bulb Requirements

MAINTENANCE

WARNING

Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons.

LIGHT BULB REPLACEMENT

Allow at least 5 minutes for light bulbs to cool before touching bulbs to avoid accidental burning of skin.

Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log ember bed exterior disappears. There are four bulbs under the log set, which generate the flames and embers, and two bulbs above the log that illuminate the log exterior.

LOWER LIGHT BULB REQUIREMENTS

Quantity of 4 clear chandelier or candelabra bulbs with an E-12 (small) socket base, 60 watt rating. Example: GE 60BC or Philips 60 CTC.

DO NOT EXCEED 60 WATTS PER BULB

HELPFUL HINTS

It is a good idea to replace all light bulbs at one time if they are close to the end of their rated life. Group replacement will reduce the number of times you need to open the unit to replace light bulbs. Care must be taken when removing the logset as the logset contains LED’s and wires.

To access the lower light bulb area:

1.Open the bi-fold doors.

2.Pull the front edge of the plastic ember bed or plastic grate up and forward until the rear tab releases from the ledge located at the bottom of the mirror.

IMPORTANT
ONLY handle the logset by the emberbed.
NOTE
Logset fits tightly into firebox, some force may		Light Bulb
be necessary to remove.
3.	Set logset in front of firebox.	LED Wire
4.	Disconnect the logset LED wire harness	Harness
	from unit.
5.	Lift the left side of the flame rod out of
	the mounting bracket.
6.	Examine the bulbs to determine which
	bulbs require replacement.
7.	Unscrew bulbs counter clockwise.
8.	Insert new bulbs.
9.	Install the left side of the flame rod to
	the mounting bracket.	Logset
10. Reconnect the logset LED wire harness.			FIGURE 7
11.Replace the logset by inserting the front of
	the emberbed under the front edge of the
	fireplace and push down on the rear edge of
	the emberbed until it snaps into place
	(FIGURE 8).
NOTE
Ensure the logset is installed tightly under the back ledge
to prevent light leakage.		FIGURE 8
12. Close the bi-fold doors.			13