NOTE
When the Low Battery icon 
is present on the remote control it is recommended to replace the batteries promptly, to maintain full functionality of the remote/fireplace (FIGURE 5).
INITIALIZING THE REMOTE CONTROL
1.Plug cord into 120 volt wall outlet.
2.Turn ON the electrical power at the circuit breaker.
3.Ensure the Main On/Off switch located inside the fireplace in the upper right hand
corner is in the ON position.
4.Set the 3 position manual control to the Remote position (left position).
5.Press and hold the initialization button on the unit.
6.While holding the initialization button, press the flame/heat ON/OFF 
button or the Purifire™ ON/OFF 
button on the remote control transmitter.
7.Release the initialization button on the unit.
8. Press the Flame/Heat On/Off button | to turn the Flame/Heat function ON or press the | |
Purifire™ On/Off button | to turn the Purifire™ function ON. | |
SERIAL No.
XXX
XX
|
| Main |
|
| On/Off |
Initialization | Switch | |
| ||
| Button |
|
Indicator | 3 Position |
|
Light |
| |
Manual |
| |
Control
FIGURE 4
FREQUENCY INTERFERENCE
If the fireplace does not respond properly to the remote control, the remote operating frequency may have to be reset. The remote control can send another frequency code to the circuit board to eliminate interference.
1.Press the Flame/Heat On/Off button 
to turn the Flame/Heat ON.
2.Press the ENTER button on the remote control, the middle display 
flashes.
3.Use the direction buttons on the hand held remote to move the cursor to 
and press
| ENTER. |
4. | Press and hold the initialization button on the unit. |
5. | Press and hold left direction button on the remote control. |
6.A descending bar graph will appear on the screen.
7.The green indicator light will flash on the unit when the new frequency code has been stored.
8. Release left direction button on the remote control.
9.Release the initialization button on the unit.
10.Press ENTER to return to the main menu.
11.Press the Flame/Heat On/Off button 
to turn the Flame/Heat function ON or press the
Purifire™ On/Off button | to turn the Purifire™ function ON. | 7 |
|
|
