Directed Audio XTR2502, XTR5002 owner manual Bridge Configuration

Bridge Configuration

Bridging allows one speaker to be driven at a higher power level from the amplifier..

+	_	+	_
			R CH
	L CH

Figure 11

Figura 11

Abbildung 11

Three Channel (Channel 1, Channel 2, Bridged)

•Left and Right are configured for two-channel stereo operation..

•Lowest recommended impedance is 2Ω stereo..

•The third output is configured for a single channel bridged out- put..

•The bridged outputs lowest recommended impedance is 4Ω..

•Outputs are configured for high-pass, low-pass, or full range operation..

+	_	+	_
			R CH
	L CH

Figure 12

Figura 12

Abbildung 12

NOTE: To get full output in this configuration, band limiting filters as shown in this diagram may need to be used to prevent the impedance from dropping too low and engaging protection circuits..

© 2008 Directed Electronics. All rights reserved. 10