Other Information
Remote Control Problems
Problems with the remote control
4Check that nothing is between the remote control and the remote sensor.
4Make sure the remote control is in DIRECTV mode. Slide the mode switch to the DIRECTV position so the remote will control the DIRECTV Receiver.
4Check the batteries in the remote control. They may be weak, dead or installed incorrectly. Try replacing batteries.
4If you’re entering a channel number that is less than four digits long, the receiver might wait two seconds before tuning to the channel. Press ENTER after entering a channel number to tune immediately.
4If you are trying to operate a device other than the DIRECTV Receiver that you have programmed the remote to control, make sure you fi rst slide the input switch to the corresponding device (DVD player, VCR, etc.). The indicator light for the component you’re trying to control should light up when you press a valid key for that component. If it doesn’t, make sure the input switch is clicked into the correct position.
A remote control indicator light starts flashing.
The batteries in the remote control are running low and should be replaced soon. (Note that when you replace the batteries,
you may have to reprogram your remote to control other devices.)
