DP564 Multichannel Audio Decoder Streaming Server and Remote Software
8-2
CD-ROM Installation
To install DolbyRemote 564 on your computer:
1. Place the CD-ROM in the PC.
2. The installation program should run automatically. If nothing happens, open
the Run prompt (click the Start menu, then Run) and type d:\setup.exe
(where d is the letter of your CD- or DVD-Rom drive).
3. Follow the on-screen prompts to install.
4. Use the default destination or select an alternate location for the software
installation.
8.4 Launching the Application Configure the DP564 network settings parameters from the front panel prior to
launching the DolbyRemote 564 software. If you are using an Ethernet connection,
these settings are found in the System Settings, Network Settings setup menus. If you
are using a serial connection, you must configure the Remote Baud Rate and Unit
Address found in the System Settings menu.
Upon launching the application, the Open Connection to DP564 window is
displayed. The PC network settings should reflect the DP564 network settings.
DolbyRemote 564 can also be opened in Off Line mode to view the application
without a hardware connection.
Before you click OK to begin remote software operation of the DP564, on the DP564
front panel, press Shift once so that the button illuminates, then press ◄. (Do not hold
down Shift while pressing ◄.) To disable remote operation and resume using the
front-panel interface, press Shift, ◄ again.
8.5 DolbyRemote 564 Overview DolbyRemote 564 offers a complete combination of setup, control, and emulation
features available on the DP564. Many of these features can display simultaneously.
The main section of DolbyRemote 564 supplies access to the features available on the
front panel of the DP564, while the tab section in the upper right-hand corner offers
the status and setup functionality available on the DP564 front-panel display and
menus.