Dolby Laboratories DP600 3.1.2 Rebuilding a Drive

Maintaining the DP600 Hard Drives
Dolby® DP600 Program Optimizer Manual 49
3.1.2 Rebuilding a Drive
TorebuildaDP600harddrive:
1. PlacetheDP600inanidlestatebyhaltingallworkordersbeingprocessed.
2. Determinewhichphysicalharddrivehasfailed(1,2,3,4,or5)bycheckingthedrive
LEDsontheDP600frontpanel,asdescribedinMaintainingtheDP600HardDrives
onpage 43.
3. Shutdowntheunitbyclickingthepowerbuttoninthesystemscreen,thenremovethe
faileddrivefromitsslotfollowingtheinstructionsinReplacingaDriveonpage44.
4. BesureamonitorandkeyboardareconnectedtotheDP600,thenreconnectthe
power.
5. Press<Alt>+<3>whenpromptedtoaccessthe3ware® BIOSManager.
Atthispoint,areddialogboxinformsyouthatadegradeddiskarrayisinstalled.Press
anykeytocontinue.
IfyoureplacedoneoftheRAIDdrives(physicaldrives1or2):
•Usethearrowkeysonthekeyboardtoselect(highlight)theavailabledrive,then
pressthespacebartoselectit.
•UsethearrowkeystoselecttheRAIDmarkedasdegraded,thenpressthespace
bartoselectit.
•Pressthe<Tab>keytoselectMaintain Unit,thenpress<Enter>.
•UsethearrowkeystoselectRebuildinthepop‐upmenu,thenpress<Enter>.
AlistappearsthatshowswhichRAIDdriveisdesignatedforrebuilding.
•Press<Enter>toselectOK.
•Press<F8>,thentypeY toacceptyourentriesandallowtheunittoreboot.
IfyouarerebuildingonlytheRAIDarrayanddidnotreplaceaRAIDdrive:
•UsethearrowkeysonthekeyboardtohighlighttheRAIDmarkedasdegraded,
thenpressthespacebartoselectit.
•Pressthe<Tab>keytoselectMaintain Unit,thenpress<Enter>.
•UsethearrowkeystoselectRebuildinthepop‐upmenu,thenpress<Enter>.
AlistappearsthatshowswhichRAIDdriveisdesignatedforrebuilding.
•Press<Enter>toselectOK.
•Press<F8>,thentypeYtoacceptyourentriesandreboottheunit.
DependingontheoriginalsizeoftheRAIDarray,arebuildwilltakefromoneto
severalhourstocomplete.Duringthistime,thesystemoperatesnormally.
Ifyoureplacedasinglenon‐RAIDdrive(physicaldrives3,4,or5):
•UsethearrowkeystohighlightthenewdrivethatappearsintheAvailable Drives
area,thenpressthespacebartoselectit.
•Pressthe<Tab>keytomovetothemenubuttonsatthebottomofthescreen,then
usethearrowkeystoselecttheCreate Unitbutton,andpress<Enter>.
TheavailableunitshouldnowappearintheCreate a disk array from these drives
box.
•UsethearrowkeystoselecttheOKbutton,thenpress<Enter>.
Note: Onsomesmallerkeyboardsyoumayneedtopress<F‐Lock>toenablethe<F8>
functionforthedual‐usekeys.