Dolby Laboratories DP600 3.3 Upgrading/Installing the DP600 Software

Upgrading/Installing the DP600 Software
Dolby® DP600 Program Optimizer Manual 55
3.3 Upgrading/Installing the DP600 Software
TheDP600packingkitincludesaninstallationDVD.Withthisdisc,youcanperforma
cleaninstallationoranupgradeoftheDP600software(ifrequired).Acleaninstallation
restorestheDP600tothefactorysettings.Anupgradesimplyupdatesthesoftwaretothe
latestrelease,retainingallyourcustomsettings.Toperformanupgradeoraclean
installationoftheDP600software:
1. ObtaintheDP600DVDfromDolby,andbesuretheprovidedkeyboardisconnected
tooneoftheunit’sUSBports.
2. InserttheDVDintheCD/DVDdrive,andrebootthesystem.
Amessagesaysthatthesoftwareisalreadyinstalledanddisplaysthecurrently
installedversionandtheversionontheDVD.Itpromptsyou toeithertype yto
upgradeorpressanykeytostartacleaninstallation.
3. Pressy toupgradeorpressanykeytostartacleaninstallation.
Theupgradeorcleaninstallationprocessbegins.Whenthenewsoftwareiscompletely
installed,youarepromptedtopressanykeytoreboot,andtoremovetheDVD.
4. PressanykeytorebootandremovetheinstallationdiscfromtheCD/DVDdrive.
Whenthesystemreboots,ifthediscisstillintheCD/DVDdrive,acleaninstallation
begins.
Your DP600touchscreenwascalibratedduringthemanufacturingprocess,butyou
mayneedtorecalibratethetouchscreenafteracleaninstallation.WhentheDP600
rebootsafteracleaninstallation,thecalibrationsetupappearsonthefront‐paneltouch
screen.Thecalibrationsetupenablesyoutoconfigurethetouchscreen,soitresponds
properly.Tocalibratethetouchscreen,youneedtoproceedasfollowswithin
approximately30secondsfromthetimeitappears.Ifyoudonotproceedwithinthis
timeperiod,thecalibrationscreendisappears.
Asmalltargetappearsattheupperleftcornerofthecalibrationsetup,andacross
appearsateachoftheotherthreecorners,asshowninFigure 3‐16.Tocalibratethe
touchscreen:
•Pressthetargetattheupperleftcornerforacoupleofsecondsuntilitchangesto
across.
Thecrossattheupperrightcornerchangestoatarget.
•Pressthetargetattheupperrightcorneruntilitchangestoacross.
• Continuetheaboveprocedureatthelowerleftcornerandthelowerrightcorner.
Whenthecalibrationiscomplete,theDP600Welcom e!screenappears,providing
achecklistofthingsyouneedbeforeyoucanreconfigureyoursystem,asshown
inFigure2‐3.FollowtheinstructionsinStartingtheSystemfortheFirstTimeon
page 10toreconfigureyoursystem.
Figure3‐16 
Figure 3-16 Calibration Setup Screen
Press target