Drive Medical Design 14000 Cleaning, Front Panel, Pressure SET UP, Audible and Visible Alarm

Front

1. Quick Connector

2. Front Panel

3. Handle

4. Auto Fowler Boost Adaptor

Rear

1. Power Switch

2. Power Socket

3. Fuses

4. Mounting Bracket

5. Blower Bumper

6. Air Filter

2.3 FRONT PANEL

1. ComfortLevel

Comfortlevel controls the air pressure output. When turning up ( ), the output pressure will increase and higherpressure output will support the heavier weight user. Vice versa( )for decreasing air pressure.

NOTE:Maximum Weight Capacity : 200kg or 440 lbs (for 35.4”model) 450kg or 1,000lbs (for 48” model)

9

4.3 PRESSURE SET UP

Users can adjust pressure of air mattress to a desired softness by adjusting the Comfort Level. Please consult your physician by the below weight support range for a suitable setting.

NOTE:Maximum Weight Capacity : 200kg or 440 lbs (for 35.4”model) 450kg or 1,000lbs (for 48” model)

4.4AUDIBLE AND VISIBLE ALARM

When the following situation occurred, the LED lights will light up along with the buzzer.

4.4.1CPR – When CPR or quick storage is performed, or the Quick Connector is on Disconnect position under power on situation, the “CPR” indicator (orange LED) will light up along with buzzer.

4.4.2Power Failure – When electrical shortage occurred or power cord is disconnected without turning off the blower first, the “power failure” indicator (orange LED) will light up along with buzzer. Check to ensure power cord is connected properly.

4.4.3Low pressure – When an abnormal low pressure occurred in body section, the “Low Pressure” indicator (orange LED) will light up along with buzzer. Check all tubingsare correctly installed as per installation instructions and ensure all tubingsare secured properly. The Low Pressure indicator will continuously light up until the low-pressure fault condition is resolved.

4.5ALARM MUTE

When these situations mentioned above occurred, both the LED light and buzzer will sound off to warn the patient. By pressing the button, it will temporary mute the buzzer (CPR & Low Pressure) so the caregiver may check for possible causes. Should the CPR &low pressuresituation not resolved within 3 minutes, the alarm will resume to beep. When in Power Failure situation, pressing alarm mute button, it will cease the buzzer and turn off the “power failure” indicator.

5. CLEANING

By wiping the blower unit with a damp cloth pre-soaked with a mild detergent, and keep it away from dust. If other detergent is used, choose one that will have no chemical effects on the surface of the plastic case of the blower unit.

CAUTION: The Fowler Boost Sensor Pad should be always kept away from water.

CAUTION: Do not immerse or soak blower unit.

10

5