.Enter'5'to③change thecurrent disk drive and press 'ENTER'.
. Select the drive you want to install and format, in this example disk '2' but note that this④
may vary from your set up!
⌕If you can not see the external hard drive at this point, ple ase check your jumper settings,
cable connection, power supply and if required, the driver installation.
For 2.5" Hard Drive, you can a lso connect the drive d irectly to your inte rnal IDE⌕bus if you
encounter problems with the ex ternal drive and install it later formatting .
. Choose '1' to⑤create a prima ry DOS partition and follow the on screen instructions. After you
have created the partition according to your requirement, close the MS-DOS command
prompt by typing 'exit' and press 'ENTER'.