NORMAL OPERATION
Match Lighting Your Grill Main Burners
mDANGER: Failure to open the lid while igniting the barbecue’s burners, or not waiting five minutes to allow the gas to clear if the barbecue does not light, may result in an explosive
A)Open the lid (1) and make sure that all burners are in the “OFF” position (2).
B)Turn the cylinder on by slowly turning the cylinder valve counterclockwise (3).
mWARNING: The burner control knobs must be in the OFF position before turning on the LP cylinder valve (3). If they are not in the OFF position, when you turn on the LP cylinder valve, the “excess gas flow control” feature will activate, limiting the flow of gas from the LP cylinder. If this should occur, turn OFF the LP cylinder valve and burner control knobs. Start over.
mDANGER: When the “excess gas flow control” feature is activated, a small amount of gas is still flowing to the burners. After turning off the LP cylinder valve and burner control knobs, wait at least five minutes for the gas to clear before attempting to light the grill. Failure to do so may result in an explosive
C)Ignite the burners individually from left to right. Begin with the burner on the left (4). Put match in the match holder and strike match. Insert match holder with lit match
(5) down through cooking grates, past the heat distribution plates and adjacent
to the left burner. Push control knob in and turn it to HIGH to ignite the left burner. Check that the left burner is lit by looking through the cooking grates. You should see a flame (6).
ARRÊTÉ - OFF - APAGADO
2 |
|
|
|
|
HIGH |
|
|
|
|
| LOW |
|
|
|
MED |
|
| 1 |
|
MAIN BURNER |
|
|
|
|
| 5 |
|
| 6 |
|
|
|
| |
|
|
|
| 2 |
| 4 | 7 |
|
|
|
| 10 |
| |
|
|
| 3 | |
3100 |
|
|
| |
|
|
|
|
| 1 |
m WARNING: Do not lean over the open barbecue. |
D1) (MODEL 3100 ONLY) |
|
|
Ignite center burner (7) by putting match in the match holder and striking match. | 5 |
|
Then, insert match holder with lit match down through cooking grates, past the heat |
| |
distribution plates and adjacent to the center burner. Push control knob in and turn |
| |
it to HIGH to ignite the center burner. Check that the center burner is lit by looking |
|
|
through the cooking grates. |
|
|
OR |
|
|
D2) (MODEL 4100/4200) |
|
|
a) Ignite |
|
|
match. Then, insert match holder with lit match down through cooking grates, | 4 8 |
|
past the heat distribution plates and adjacent to the |
| |
control knob in and turn it to HIGH to ignite the | 9 10 | |
| ||
b) Next, ignite |
|
|
striking match. Then, insert match holder with lit match down through cooking | 4100/4200 |
|
grates, past the heat distribution plates and adjacent to the |
|
Push control knob in and turn it to HIGH to ignite the
E)Ignite right burner (10) by putting match in the match holder and striking match. Then, insert match holder with lit match down through cooking grates, past the
heat distribution plates and adjacent to the right burner. Push control knob in and turn it to HIGH to ignite the right burner. Check that the right burner is lit by looking through the cooking grates.
mWARNING: If any burner fails to ignite during lighting, within
five seconds, stop, turn the burner control knob to OFF and |
|
wait five minutes to allow the gas to clear before you try |
|
again or light with a match. | 5 |
|
6 2
3
6 |
29