Dynacord DTI 2000 owner manual SW1 SW2 SW3 SW4 Timeout

than the specified maximum connection timeout setting allows. If the caller does not enter any new selection during the connection timeout, the DTI 2000 automatically finishes the momentary announcement and releases the PA-system. Afterwards, the telephone connection is disconnected as well.

Switches 1 – 4 are used to set the maximum timeout for a connection as indicated in the following table:

SW1	SW2	SW3	SW4	TIMEOUT
OFF	OFF	OFF	OFF	OFF
ON	OFF	OFF	OFF	20 sec.
OFF	ON	OFF	OFF	30 sec.
ON	ON	OFF	OFF	45 sec.
OFF	OFF	ON	OFF	60 sec.
ON	OFF	ON	OFF	75 sec.
OFF	ON	ON	OFF	1.5 min.
ON	ON	ON	OFF	2 min.
OFF	OFF	OFF	ON	2.5 min.
ON	OFF	OFF	ON	3 min.
OFF	ON	OFF	ON	3.5 min.
ON	ON	OFF	ON	4 min.
OFF	OFF	ON	ON	5 min.
ON	OFF	ON	ON	6 min.
OFF	ON	ON	ON	8 min.
ON	ON	ON	ON	10 min.

CAUTION:

The DTI 2000 is factory pre-set to a maximum connection timeout of 1.5 minutes (SW1 = OFF, SW2 = ON, SW3 = ON, SW4 = OFF).

Setting the switches 1 – 4 to their OFF- position specifies an infinite timeout, i.e. the connection is not automatically disconnected.

Switches 5 – 8 are not in use and should be left in their OFF-position.

3.Rack installation

There are two rack-mounting options for the DTI 2000. Use the MCP-2 rack installation kit for installing a single DTI 2000 and the MCP-1 for installing two units next to each other in a rack system. The following diagram shows both options.

4. Connections

4.1 Connecting the DPM 4000 System Manager

DTI 2000 Manual e EDITED.doc 7