Dynacord owner manual Operating the DTI, DTI 2000 Parameters Default Configuration Remarks

6.Country settings

Different countries and regions have different telephone standards, which may differ in e.g. signal level and dial tones. The DTI 2000 can be and should be configured to meet those individual requirements. Not doing so can result in faulty operation of the DTI 2000.

Generally, the DTI 2000 is factory pre-set prior to shipping. In case of problems, please contact the nearest service-centre or the technical support.

Operating the DTI 2000

First, make sure that the DTI 2000 has been correctly installed and connected, as described before. Be sure to check the address and DIP-switch settings.

The DTI 2000 has a Default Configuration, which suits most standard applications. Custom configuration of the DTI 2000 is possible using the PC Designer Software, which is explained in detail in the chapter “Configuring the DTI 2000”.

DTI 2000 Default Configuration:

DTI 2000 Parameters	Default Configuration		Remarks
NAME	DTI-2000		Default Name
COMP	OFF		No meaning in the DTI 2000
BUZZER	OFF		No meaning in the DTI 2000
PRECHIME	OFF		No meaning in the DTI 2000
GERMAN	OFF		No meaning in the DTI 2000
DOSCHAR	OFF		No meaning in the DTI 2000
PTTPRIO	INT		No meaning in the DTI 2000
EXT	4350		No meaning in the DTI 2000
PASSW	111,2222		Level 1 / Level 2 passwords
GROUP0	NONE		No groups programmed
…	…
GROUP20	NONE
KEY1	SELECT 1		Call number table:
KEY2	SELECT 2		No. 1 (01) = Zone 1
…	…		No. 2 (02) = Zone2
…	…	...
KEY99	SELECT 99		No .99 = Zone 99
KEY100	SELECT 100		No. 0 (00) = Zone 100
KEY101 … KEY107	DISABLED		No meaning in the DTI 2000
KEY108	TALK,255,0,20		Talk in actual selection with priority 2
KEY109 … KEY112	DISABLED		No meaning in the DTI 2000

The DTI 2000 decodes all DTMF dial tones as well as signal tones for the recognition of incoming phone calls, pressed keys and determination whether a connection has been dropped or if the calling party hung up. Each one or two-digit number between 0 (00) and 99 represents an individual function, which is assigned in a calling numbers table (either in the Default Configuration or via user configuration). Three or four-digit numbers are used for entering passwords. The asterisk (*) and hash mark (#) keys offer special functions; e.g. as separator, for clearing faulty entries (Clear), as talk button, or to drop a connection.

1.Telephone call to the DTI 2000

Simply dial the number of the telephone line to which the DTI 2000 is connected. You are presented either with a ring signal when the line is not busy, or otherwise with a busy signal when the line is already busy. After the specified ring count (refer to DIP-switch S202) the DTI 2000

DTI 2000 Manual e EDITED.doc 9