Chapter 5:Connection Mode
Chapter 5
Connection Mode
Prior to configuring the ADSL Router, you must decide whether to configure the ADSL Router as a bridge or as a router. This chapter presents some deployment examples for your reference. Each mode includes its general configure procedures. For more detailed information about web configuration, refer to "Web Configuration".
PPPover ATM (PPPoA) PPPoA IP Extenstion PPP over Ethernet (PPPoE) PPPoE IP Extension MER Mode
Numbered IP over ATM (IPoA) Numbered IP over ATM (IPoA)+NAT Unnumbered IP over ATM (IPoA) Unnumbered IP over ATM (IPoA)+NAT Bridging
For making sure that you can connect the ADSL to your computer well and get into Internet successfully, please make sure the following first.
Make sure you have installed a network interface card into your computer. Make sure the connection between the ADSL and your computer is OK.
Check to see the TCP/IP protocol and set the IP address as “Auto Get IP Address”.
When you are sure all above is Ok, you can open the Browser and type in “192.168.1.1” and start to do the web configuration with different connection modes.
This chapter is going to introduce the function of each connection mode and tell you the basic configuring steps that you have to do. If you did not follow the configuring steps for using these connection modes, you might get some connection problems and cannot connect to Internet well.
69
