ADSL Router User Manaul
PPP over Ethernet (PPPoE) Mode
Dynamic Public IP | Default Private IP |
assigned by BRAS | 192.168.1.1 |
ISP |
|
|
| 192.168.1.3 |
(Internet Service Provider) | Loop |
|
| |
|
|
|
| |
|
|
|
| Ethernet |
BRAS |
|
| ADSL | Hub |
| DSLAM |
| ||
| Router |
| ||
AAA |
|
|
| 192.168.1.2 |
|
|
|
| |
RDAIUS |
|
|
|
|
Server |
|
|
| PC(S) |
|
|
|
| |
*BRAS: Broadband | PPP over Ethernet |
| ||
|
|
|
| |
Remote Access Server | PPPoE+NAT+DHCP |
|
| |
|
|
| ||
| on Private LAN |
|
| |
Description:
In this deployment environment, the PPPoE session is between the ADSL WAN interface and BRAS. The ADSL Router gets a public IP address from BRAS when connecting to DSLAM. The multiple client PCs will get private IP address from the DHCP server enabled on private LAN. The enabled NAT mechanism will translate the IP information for clients to access the Internet.
Configuration:
1.Start up your browser and type 192.168.1.1 as the address to enter this ADSL
2.Go to Quick Setup. Type in the VCI and VPI value. Then click the Next button. eg:
VPI – 0 VCI – 39
3.On the Configure Internet Connection
4.In the PPP Username and Password page, enter the PPP username and password that you got from your ISP.
5.Select Dial on Demand and type in the number for inactivity timeout. The default is 20. Or select Always on.
6.In the Configure LAN side Settings page, type in the IP address and subnet mask for your LAN. Check Enable DHCP Server on the LAN box. And type in the start and end points. Then type in the leased time that you want. Finally click Next. eg.:
Primary IP address:192.168.1.1 Subnet Mask:255.255.255.0 Start IP Address:192.168.1.2 End IP Address: 192.168.1.254
7.Check the network information. Make sure the settings match the settings provided by ISP. Click Finish.
72
