Eagle Electronics 500C, 500CDF manual Shoot-Thru-Hull Installation

with the boat on plane and observe the bottom signal. You'll need to figure some way to prop the transducer into position while you make your test run. (A brick or two might be sufficient to hold it in place.)

5.When you're satisfied with a location, mark it and proceed with the installation.

Shoot-Thru-Hull Installation

If you are installing the transducer on a hull with floatation material sandwiched within the hull, refer to the text "Hulls With Flotation Ma- terials" beginning on page 26.

1.Make sure the area is clean, dry and free of oil or grease, then sand both the inside surface of the hull and the face of the transducer with

100grit sandpaper. The sanded hull area should be about 1-1/2 times the diameter of the transducer. The surface of the hull must be flat so the entire transducer face is in contact with the hull prior to bonding. After sanding, clean the hull and transducer with rubbing alcohol to remove any sanding debris.

Spread epoxy here

Sand this surface (unit's face)

Orient the Skimmer with the nose facing the bow of the boat.

To bow

Epoxy transducer to hull.

WARNING:

Use only the epoxy available from LEI. It has been for- mulated to work with these installation procedures. Other epoxy types may be too thin or may not cure to the right consistency for optimum transducer performance.

2.The epoxy consists of the epoxy itself and a hardener. Remove the two compounds from the package and place them on the paper plate.

28