Starting Cold Engine

PB-770 H/T

OPERATION

 

 

Starting Cold Engine

Recoil starter: Use short pulls - only 1/2-2/3 of rope length for starting. Do not allow the rope to snap back in. Always hold the unit firmly.

(PB-770H): Rotate spring loaded throttle arm downward to a comfortable operating position.

-PB-770 H

1.Throttle Lever

Move throttle position lever (A) to IDLE DETENT positions.

-PB-770 T

1.Throttle Position / Stop Switch Button

Slide Throttle Position / Stop Switch Button (A) back to idle position.

- PB-770 H and T

2.Choke

Move choke (C) up to Cold Start Position ( 1.Throttle Lever )

3.Purge Bulb

Pump purge bulb (D) until fuel is visible. Pump bulb an additional 4 or 5 times.

4.Recoil Starter

Pull recoil starter handle (E) until engine fires, or a maximum of 5 pulls

5.Choke

PB-770 H

A

PB-77- T

C 1.Throttle Position / Stop Switch Button

E

D

After engine fires (or 5 pulls), move choke lever back to Run ( 2.Choke ) position, then pull starter handle/rope until engine starts and runs. Allow unit to warm up at idle for several minutes.

Note: If engine does not start with choke in “Run” position after 5 pulls, move choke to “Cold Start” ( 3.Purge Bulb ) position, and repeat steps 4 & 5.

6.Throttle Lever

Allow engine to warm up for several minutes before use.

7.Throttle Lever

After engine warm-up, move throttle lever gradually to increase engine RPM to desired operating speed.

X7531123904

19

© 4/2013 ECHO Inc.

Page 19
Image 19
Echo PB-770 H/T Starting Cold Engine, Throttle Lever, Throttle Position / Stop Switch Button, Choke, Purge Bulb, Operation