Eclipse - Fujitsu Ten CD5444 owner manual How to operate the ESN Memory Stick security

ESN security operating procedure

Buttons [1] to [4]

[FUNC] button

How to operate the ESN (Memory Stick) security

How to record a security code

1Check that the Power is OFF.

2Press and hold button [1], then the [FUNC] button, and hold both for more than one second.

A [SEC] message appears, in two seconds it will change to [MS].

•If a Memory Stick has already been inserted, a [MS EJECT]

ATTENTION message appears. In this case, eject the Memory Stick and insert again. (Refer to "Ejecting the Memory Stick" on page 72

for details on ejection of the Memory Stick.)

•If a security is activated, recording the security code is not available.

3Insert the Memory Stick into the slot.

A [- - - -] (security code input display) appears.

(Refer to "Listening to MG Memory Stick" on page 40 for details on insertion of the Memory Stick.)

4Input a security code by pressing buttons [1] to [4]. Enter a four-digit security code using digits 0 to 9, A to F. The number (shown on the display) changes in ascending order between 0 and 9, A and F each time the button is pressed. Each button number (1 to 4) corresponds to each digit (first to forth) of the security code.

26