CHAPTER IV: APPENDIX
4.1 Troubleshooting
Please don’t panic when you found this NVR is not working properly. Before you send this NVR back to us, you can do some simple checks to save your time:
| Problem | Solution | |
|
|
|
|
| Cannot connect to the NVR | 1. Please check the IP address of NVR again. | |
|
| 2. Please make sure the network cable is correctly | |
|
|
| connected to your local area network. |
|
| 3. Please make sure power cable is correctly connected | |
|
|
| to NVR. |
|
| 4. Please make sure NVR is switched on (the LED lights | |
|
|
| on front panel or NVR will light up). |
|
|
|
|
| No network camera found | 1. ‘Auto search’ function only works on IP cameras | |
|
|
| located on local area network. To add a remote IP |
|
|
| camera, you must use manual configuration. |
|
| 2. | Only ‘EDIMAX’ IP cameras are supported currently. |
|
|
|
|
4.2 Specifications |
|
| |
|
|
|
|
| Description |
| 4 CH Network Video Recorder |
| Microprocessor |
| Cavium |
| Flash ROM |
| 32 MB |
| RAM |
| 256 MB |
| Supported Image Format |
| H.264 / |
| Maximum Number of Cameras | 4 Channels | |
| HDD Type |
| SATA I/II/III Compatible |
| HDD Bay & Max. Capacity |
| 2 Bays ; Total capacity: 2TB x2 ( SATA 3.0 ) |
| RAID |
| Standard, RAID 0, 1(Mirror) |
| Network Interface |
| 10/100/1000 Mbps RJ45 Ethernet port |
| USB |
| USB 2.0 x 1: supporting |
| Buttons |
| Reset / Power on/off |
| LEDs |
| Power / Network Indicator / HDD Status Indicator / |
|
|
| USB Indicator |
| Recording Mode |
| Continuous / Manual / Schedule /Motion Detection |
| Alarm |
| Yes |
| Event |
| Yes |
| Snapshot |
| Yes |
|
|
|
|
84
