Edirol R-4Pro Wave edit button [WAVE EDIT], Effect button [EFFECTS], System button [SYSTEM], Marker [MARKER], A-B Repeat button [A-B REPEAT], Display button [DISPLAY]

Introducing the R-4 Pro

Wave edit button [WAVE EDIT]

This button takes you to Wave Edit mode, where you can edit the waveform using operations such as Trim,

Divide, Combine, and Merge. For details, refer to “Editing” (p. 51).

You won't be able to enter Wave Edit mode during playback or recording, or if the R-4 Pro’s hard disk

contains no files that the R-4 Pro can handle.

WAV files are the only type of files that the R-4 Pro can handle.

Effect button [EFFECTS]

This button takes you to Effect mode, where you can make effect settings.

For details, refer to “Effects settings” (p. 59).

System button [SYSTEM]

This button takes you to a mode where you can make various settings for the R-4 Pro.

For details, refer to “System setup” (p. 64).

Marker [MARKER]

Clear button [CLEAR]

This button deletes markers you assigned using the Mark button. Markers are deleted successively, starting

at the marker located immediately before the current location.

button

This button moves you to the marker that is immediately before the current location (the previous marker).

If the current playback location is earlier than the first marker, pressing this button will take you to the

beginning of the project. You will also move to the beginning of the project if no markers have been set.

button

This button moves you to the marker that is immediately after the current location (the next marker).

If the current playback location is at the last marker, pressing this button will take you to the end of the

project. You will also move to the end of the song if no markers have been set.

Mark button [MARK]

By pressing this button you can assign a marker to a desired location in the project file. Markers are

numbered sequentially from the beginning of the project.

A-B Repeat button [A-B REPEAT]

This button lets you repeatedly play back the region between two points (A and B) in the project. Simply

assign marker A and marker B while the project is playing, and playback will repeat between markers A

and B.

fig.repeat-a

1. During playback, press the A-B Repeat button once.

That point becomes the beginning (marker A) of repeat playback.

fig.repeat-b

2. Press the A-B Repeat button once again. That point will be the end

(marker B) of repeat playback.

fig.repeat-ab

The region you specified in steps 1 and 2 will play repeatedly. To cancel repeat

playback, press the A-B Repeat button once again.

Display button [DISPLAY]

This button switches the contents of the R-4 Pro’s display.

For details, refer to “Display” (p. 18).

R-4_e_new.book 11 ページ２００６年１１月２０日　月曜日　午後１時９分