88
Appendix
Setting the REC-RUN timecode start time
fig.recording-1.eps
1Press the [SYSTEM] button on the R-4 Pro.
The display shows the System Menu screen.
fig.time-code-1.eps
2Use the [CURSOR] button to select 6 Timecode, and
press the [ENTER] button.
The Timecode screen is shown.
fig.time-code-set-rec.eps
3Use the [CURSOR] button to select 3 Set Rec-Run TC,
and press the [ENTER] button.
The display shows the Set Rec-Run TC screen.
fig.time-code-6.eps
4Use the [CURSOR] button to select the input location,
and then set the start time with the [SCRUB/VALUE]
dial.
* H:M:S:F: indicates Hours :Minutes :Seconds :Frames, respectively.
The F value differs according to the Frame Rate value in the Timecode
Setup.
* To cancel the settings, press the [EXIT] button.
fig.time-code-7.eps
5Press the [ENTER] button.
The set time is displayed and the timecode begins.
6After setting the value, press the [EXIT] button.
The display returns to the Timecode screen.
7Return to the Main screen by pressing the [EXIT] button
again.
R-4_e_new.book 88 ページ ２００６年１１月２０日　月曜日　午後１時９分