EFJohnson VR-CM50 manual Main Console Assembly, C A U T I O N, 2WRITING SUPPORT MOUNTING HOLES

CABINETRY ASSEMBLY FOR CRT CONSOLE SYSTEMS

3.4 MAIN CONSOLE ASSEMBLY

4.Remove the front and rear keylocked enclosure pan- els from each bay and set them aside.

C A U T I O N

Keylocks will scratch keylock enclosure panels if they are stacked or leaned against each other.

5.Accurately place the console section at its final loca- tion before continuing with STEP 3.

6.Using #1/4-20 x 3/4 hex bolts and #1/4-20 x 3/4 Keps nuts, attach the console sections together using pass-through holes in the sides.

Note: Be consistent when orienting the bolts in the pass-through holes. Refer to Figure 3-3.

Do not attach the consoles at the centermost holes. These holes will be used to fasten the writing sup- port rails. Refer to Section 3.7.

7.Be sure the sections are in perfect alignment before securing the fasteners.

HINT: When aligning console sections, a #2 Phil- lips screwdriver may be placed through one of the centermost holes and used as an alignment tool.

Figure 3-2 WRITING SUPPORT MOUNTING

HOLES

Figure 3-3 ASSEMBLY OF CONSOLE SEC-

TIONS

3.5CONSOLE LEVELING

1.Consider carefully where the consoles are located. Any gross unevenness in the flooring should be eliminated. Small deviations can be compensated using the individual levelers at each console.

Note: Levelers are screwed in all the way in ship- ment. Refer to Figure 3-5.

2.Level the console assembly both side-to-side and front-to-back using the threaded levelers in each cabinet section. Levelers can be adjusted by using an 1/2" open end wrench or by hand turning. Hint: a piece of scrap wood may be used to prop up the console to aid in leveling. Be sure each leveler is snug against the floor and supports its proper share of the overall weight.

NOTE: Once the levelers have been extended, do not shift the console position. Lateral movement can bend the leveler stems making proper adjust- ment extremely difficult.

February 1996
Part No. 004-3039-274	3-2