EQUIPMENT
SCREEN 1
______________________________________________________________________________________
TOUCH THE UPPER LEFT POINT USING ONLY ONE FINGER
FINGER SHOULD BE PERPENDICULAR TO SCREEN
HOLD FINGER IN PLACE UNTIL YOU ARE INSTRUCTED TO REMOVE IT
Press ANY key to ABORT calibration
______________________________________________________________________________________
SCREEN 2
______________________________________________________________________________________
AFTER PRESSING UPPER LEFT, TOUCH THE LOWER RIGHT POINT USING
ONLY ONE FINGER
FINGER SHOULD BE PERPENDICULAR TO SCREEN
HOLD FINGER IN PLACE UNTIL YOU ARE INSTRUCTED TO REMOVE IT
Press ANY key to ABORT calibration
______________________________________________________________________________________
When the calibration is complete, the message SF CAL Written, Calibration updated on Installed SFKERN Driver , will be displayed.
c:\> prompt will display:
4.Initialize the CRT Console:
Reboot the system by pressing the RESET button on the computer.
The Main Screen will then be displayed.
NOTE: if the Main Screen does not appear, check the AUTOEXE.BAT file and make sure the drivers are installed. If they are not, call for technical help if you do not know how to install them.
6.5 AFTER SYSTEM CHECK-OUT
At this point, the E.F. Johnson CRT Console system installation and checkout has been completed. If you have any questions or problems, contact Technical Sup- port,
February 1996 |
|
Part No. |